Featured 6'3" wide Dwarf Wall Alloy Finish Toughened Safety Glass

Originally intended to create a decorative finish, it has been noted by many a grower that they can now double up as a deterrent against cats and birds gaining access to the greenhouse roof.

To view more details click on the image above, this will open up a new page.

The colour of your crestings & Finials will be as per the greenhouse colour chosen.

There will be a nominal number of roof vents supplied,  according to the size of the greenhouse.

You can never have too much ventilation, if you don't need more then just leave some of the vents closed, it's always nice in the heat of the summer to be able to give your precious plants more air.

Better still, why not automate all your roof and louvre vents with one of our automatic vent openers, which open and close according to the temperature. (See below)

To view more details click on the image above, this will open up a new page.

The vent/s colour will be as per the greenhouse colour  chosen.

Elite Greenhouses Soft Soil Support goes under the drop door threshold to support it on soft soil foundations.

Please Note: If you are ordering a lean-to with a base, this will only be useful if you are ordering a dropped door into the base and erecting it on soft soil.

Modern aluminium greenhouses are designed to be constructed either on a solid foundation or directly onto the soil, however if your greenhouse is being constructed onto soil or grass, you will find that persistent stepping on the ground level door cill will cause damage, as it will naturally follow the contour of the ground so in these cases is is strongly recommended you use the soft ground support.

Please Note: The standard finish is in alloy. If colored is chosen this will be the same colour as the greenhouse

These are the three automatic roof vent opener we offer and consider them to be the best for quality and value for money.

For more detailed information click on the center image, this will open another page with full details.

Standard kit has two drainage points. The Complete To One Gutter Kit has extra fitings and goes to one drainage point, either side at the rear of the greenhouse. The image above shows the later.

Taps are included.

Diamond Shelving (please select color from below)

PLEASE NOTE: The Terracotta colour is no longer available

Click on any of the fobs above to expand a page with more details

 Please select color from below

PLEASE NOTE: The Terracotta colour is no longer available.

Click on any of the fobs above to expand a page with more details

The colour of your louvre vent will be as per the greenhouse colour.

The best position is in the center of the back panel as low as possible, so long as it is not obstructed by a fence or hedge, in this case place it in a clear panel in the side.

If you are having staging along either side it might be best to place it above the staging as it would be difficult to operate under the staging.

Please select your preferred position for the Louvre/s below.

Please Note: If the greenhouse is from the Titan range, were there is a 10 blade louvre supplied as standard which takes up twice the depth of standard louvre, it might prove difficult to fit it above the staging, therefore the centre back or along one side, where there is no staging fitted,  would be the best place to install it.

Click on one of the options in the drop-down below, to tell us where you would like your Louvre Vent/s to be positioned.

Fitting a louvre vent opener to your greenhouse louvre will provide better automatic temperature and ventilation control.

Bar Capping  (please select color from below)

PLEASE NOTE: The Terracotta colour is no longer available.

Click on any of the fobs above to expand a page with more details

A greenhouse partition is very usefull, as it enables you to establish two separate environments for your plants to grow in.

Partitions are more usefull for a large greenhouse so you can segregate part of the greenhouse off, to perhaps use as a propagation area which need more humidity and heat and then use the other section for hardier plants or to harden off  the plants you have grown in the heated area.

Or you can create an area that you can heat in the winter and overwinter some of your less hardy plants.

By heating only part of a larger greenhouse will be significantly cheaper than heating the whole greenhouse. 

The colour of the partition will be the same as the greenhouse colour.